750kg Trailer Suspension Units Wheels Tyre 145 x 10" 4PLY 4"PCD 4 Stud Hub Bear. Wheels (Pair) Specifications: High OEM quality, as used in our own trailer factory.10" Steel Wheel, 4" PCD. (See our PCD guide below if you are unsure about this) Fitted with a 14510 RADIAL Tubeless Tyre. PLEASE NOTE; If your trailer was built on second hand mini wheels like many older trailers, then this wheel is the new replacement but it has a different offset to a mini wheel. They will fit the mini hub with no problems but will stick out from the trailer just over an inch more than before. In many cases this is ok but in some cases it is necessary to space the mudguard out for it to fully cover the wheel in order to use these wheels. Guide to Wheel PCD To make sure your new wheel will fit your trailer you need to check the stud pattern size and this is known as the PCD. And is the diameter of a circle drawn through the centre of all the wheels bolt holes. On a four stud wheel this is very easy to measure, simply by measuring the distance between the centres of two diagonally opposite wheel studs as shown below. The PCD can be measured in millimetres or in inches.
Hub Specifications: This listing is for a pair of hub sets. They are available in individually or with suspension units in our shop. Fits a standard 1 trailer stub axle. 4 PCD Hub, 4 stud.Complete fitted with 3/8 wheel studs and the bearing races are already pressed into the hub, meaning no specialist tools are required to fit. Includes; 1 x Cast Hub. Suitable stub axles and suspension units are available in our shop. Suspension Unit Specifications: This listing is for a pair (left and right) of suspension units.
Fitted with standard 1 trailer stub axles. Also available with hubs in our shop. Very heavy duty construction make these suitable for daily use by business. Far tougher and long lasting than most 750kg suspension units.
Maximum weight (per pair) 750kg Features a solid suspension arm for strength and less prone to rusting than cheap hollow box section suspension arms. Complete with washers and castle nuts for mounting the hubs.Other parts such as wheels, bearings, mounting plates etc. Are available in our shop. Mounting holes sizes are as pictured. This item is in the category "Vehicle Parts & Accessories\Trailer Parts". The seller is "abtools_australia" and is located in this country: GB. This item can be shipped worldwide.